Gefran TH force transducer for tension/compression application

Product Overview:

The disposition of the (8) strain gauges of the measurement bridges use the deformation produced by the sheer force of the applied load. It is thus possible to make accurate force transducers that are rugged and insensitive to lateral loads. The transducer is machined from a solid block of stainless steel and contains no welds or joints. The electrical circuit is protected by sealed formed stainless steel plates.

Specifications:

• Accuracy: 0,2%
• Nominal full-scale load (Ln): 10...100 kN
• Nominal output at FSO:2mV/V
• Output tolerance at Ln: <± 1% FSO
• Combined errors: Nonlinearity Hysteresis, Repeatability: < ± 0,2% FSO
• Creep (after 30 min. at Ln): < ± 0,06% FSO
• Zero load out of balance signal: < ± 1% FSO
• Calibration signal: 80%FSO ± 1%
• Thermal drift in compensated range: Sensitivity: < ± 0,02% FSO°C/ Zero: < ± 0,02% FSO°C/ Calibration: < ± 0,02% FSO°C
• Nominal input resistance: 700 Ohm
• Nominal output resistance: 700 Ohm
• Nominal supply voltage: 10 V
• Compensated temperature range: -20...+50°C
• Maximum temperature range: -20...+60°C
• Permitted static load: 130% Ln
• Permitted dynamic load: 100% Ln
• Maximum applicable load: 150% Ln
• Maximum elastic deformation at Ln: < 0,2 mm
• Electrical connections: VPT02A10-6PT2
• Elastic element material and case: Stainless steel

Supplier link: https://www.gefran.com/products/strain-and-force-sensors/force/th-force-transducer/